Search:

That connector which is going to pins P4-8, P4-9, P4-10(+24VDC) is the remote start stop option and if the control is configured with this option will not run unless P4-9 is connected to +24VDC...

Just in case this comes up again; Dave over at illianaindtech has a lot of information posted on these machines.


This one would be my starting point for the issue you have: Series 1100 trouble...

There is a setting in the machine setup for how much memory to reserve for the editor (RAM) deleting files doesn't sound like your solution.

Questions:

A) Home much physical memory is in the...

Which control do you have?

When you first power on the machine the Z axis needs to be put in your "home" or tool change position and then zeroed while Tool #0 is active. You touch the other tools...

That doesn't make much sense - 4000 lines of code is nothing. Have you tried using a different disk?

I have an Anilam S1100 (albeit now upgraded to a 533Mhz CPU with 64MB of Ram and 64MB SSD)...

Press the letter for the AXIS you want to zero and it will show [0.0000] in the box on the lower half of the screen then just press enter. (Note: Do not press start as that tells the machine that you...