Search:

Sent a DM with my contact info. TY

Here's an update in case someone else runs into this with the MSC-802m control, the stuck Single Block Mode was caused by corrupt GOP memory. A fellow TV-30 owner provided the procedure to reset the...

Thanks for the parameters Mike. I loaded them up, and I also addressed the low lube alarm. There's no more alarms, yet it still wouldn't do a tool change. Then I noticed there was a stop code, T03...

It looks like I don't have any macro programs, aren't these needed? Mike, can I bother you for a complete backup of your machine? I think the one the Mori sent me is actually from a TV400 anyways, so...

Thanks Mike, I just completed the ATC arm zero referencing. I know what you mean about Z axis faulting from the load mid cycle. I had to temporarily turn up parameter 2222 which is the servo overload...

Thanks rc-monster mike. I think Mori USA may have come through. They sent me a ladder backup from a similar machine, and it looks to be working better. I've got the XYZ axes zero referenced. I think...

Thanks for the info! That's really good to know, because I have a ladder back up from a non APC machine with only the ATC as being different, 12x vs 20x. I'll try to grab the ladder diagram from Mori...

I recently purchased a Mori TV-300 drill and tap center, which was sitting around for a few years and lost its main board battery. So unfortunately it lost everything, including the parameters and...