Hi Jesse,
Would you mind elaborating on the repair? I am having a similar problem with an SKT21-LMS. M5 does not stop spindle and AL-15 SPINDLE COMMAND TIME OVER during a run.
Thanks,
Joseph
Type: Posts; User: joseph10s
Hi Jesse,
Would you mind elaborating on the repair? I am having a similar problem with an SKT21-LMS. M5 does not stop spindle and AL-15 SPINDLE COMMAND TIME OVER during a run.
Thanks,
Joseph
Mike,
I honestly don't remember exactly what I did to clear this alarm. My situation was a little different in that the pin that locks the turret into position was engaged in between two turret...
thanks for the reply, Maz. Its a fanuc oi-tc controller. I am unable to move anything because i get a AL-64 TURRET INDEX TIME OVER error when the machine starts up from power off. I cannot run the...
Help needed. I get the error message AL-64 TURRET INDEX TIME OVER when I start my Hyundai Kia skt 12lms. I bumped the turret into the main spindle while doing a tool change. The turret is stuck...
Hello,
I bumped my tool post (turret) during a tool change last week. It was the end of the day so didn't want to deal with it at the time and shut down the machine. Today when I powered up the...
I am working on a Hyundai Kia SKT 21LMS with Fanuc oi-TC controller. I am attempting to mill a 1/4" hex on the face of a 3/8" SS rod. My initial efforts have lead me to the following code which...
Thanks, Al. The unit runs pretty much nonstop, 24/7. No way to use a small DC computer fan? The reason I ask is because I see a +10V output terminal on the VFD.
Joseph
Thanks for all the help jschmitt.
A couple more questions. I am going to put this in a separate NEMA enclosure. Will i need to put a fan in the enclosure? Will two vents work? If I need a...
Thank you for your comments, Matt and Albert. The one you found, Matt, was about $30 cheaper than the cheapest I had found.
Next question, where does it get hooked up? The current...
I have a chip conveyor on my Hyundai-Kia Turning Center and I would like to adjust the speed of the conveyor to limit coolant loss. The motor is a 3-phase induction 240V 1.0A. Does anyone know of...