Search:

I have a Powermax 45 and would like to make a Interface Cable for it. Dose any one know what type connector I need to make one.

I just purchased a Powermax 45 with a T45v torch. I will be using it on a Plasmarout CNC table and was wondering what the consumables I need are. I think it will be the shielded nozzle #220671 with...

I am using a miller 625 spectrum plasma 40 Amps 30 IPM .120 cut height
with brand new tip and electrode.
It cuts fine in one direction but when it turns the corner
I get a bad angle on the...

I have had a table like this for almost 2 years. Aside from some computer problems everything has been OK. One question how is your tip life with the TD plasma? I cut ¼ plate at 60 amps and 65ipm...

I have a Plasma table that has been cutting good for a while now but my computer’s mother board died. I took the backup CD that I was given when I bought the table and installed everything on my...

What is the difference between a drag tip and a stand-off tip?
I know one is used while contacting the part and the other is above the part but what makes one a drag tip? I have a Thermodynamics...