584,805 active members*
5,200 visitors online*
Register for free
Login

Search:

Type: Posts; User: mcdrury

Search: Search took 0.00 seconds.

  1. Servo not performing the same rotation or speed in opposite directions

    I have an interesting problem; I have been doing the Auto PID for the X and Y axes and have moved on to doing the Z axis.

    I was setting the PPR as I have done on the other axes.

    When I move...
  2. Replies
    0
    Views
    6,013

    CSMIO IP-A - Mach 4 - Yaskawa

    Hi,

    I have a machine with Yaskawa Sigma II SGDH 15 Drives.

    The servos and servo drives run as I ran a test with only the servo and servo drive connected to each other asper the Yaskawa...
  3. Replies
    6
    Views
    1,945

    Mach 4 and ESS Limit/Homing Configuration

    G'day all,

    When setting up the Limits and Homing, specifically soft limits in Mach 3, I had the last 25mm before "0" home, travelling at 20% of nominal speed.

    How do I achieve the same in...
  4. Replies
    0
    Views
    715

    Mach 4 and ESS Limit/Homing Configuration

    G'day all,

    When setting up the Limits and Homing, specifically soft limits in Mach 3, I had the last 25mm before "0" home, travelling at 20% of nominal speed.

    How do I achieve the same in...
  5. Replies
    10
    Views
    1,205

    No probs. I'll try there. Thanks Ramon

    No probs. I'll try there. Thanks

    Ramon
  6. Replies
    10
    Views
    1,205

    Oops. Try again.

    Oops. Try again.
  7. Replies
    10
    Views
    1,205

    Windows 7 32 I added the parallel port 2 weeks...

    Windows 7 32

    I added the parallel port 2 weeks ago as the PC wasn't built with one.

    Screenshot attached.
  8. Replies
    10
    Views
    1,205

    Hi Doorknob, Further to that those earlier...

    Hi Doorknob,

    Further to that those earlier pin combinations show 0V when Mach3 is closed down.

    Thanks

    Ramon
  9. Replies
    10
    Views
    1,205

    Hi Doorknob, Checked pins 2/25 and 3/25 on...

    Hi Doorknob,

    Checked pins 2/25 and 3/25 on parallel port and they're reading a constant 5V.
    Jogging Mach3 has no effect.

    Mach 3 holding pulling the voltage up?

    Thanks

    Ramon
  10. Replies
    10
    Views
    1,205

    Hi Doorknob. Thanks for the reply. I have...

    Hi Doorknob.

    Thanks for the reply.

    I have a consistent voltage of 4.8V at 8-10 and on 9-10 at all times; when jogging + or - and static. Hmmm.

    Thanks

    Ramon
  11. Replies
    10
    Views
    1,205

    Stepper Holding Torque but not Jogging

    Hi all,

    I have a problem with a set up that consist of the the following gear;
    G203V
    Nema 34 - 640oz/in
    MB-03 V1 BOB

    All seems to be wired correctly, and the motor holds but wont turn when...
Results 1 to 11 of 11