Search:

Hello,
I was just looking to see if someone could confirm what I think is the issue with my machine.

I'm not a beginner with laser cutting but by no means an expert. I have changed my laser...

hello,
When I order acrylic sheet i usually get sent perspex, however this time, when the black arrived it was covered in a blue plastic covering. When I have cut with it I have found that it looks...

Thats what I was thinking but am unsure what to do about it? should I be cleaning something? I have propan 2 ol

Hi,
Cutting is fine, when I engrave 1 thin line it is engraving double, it never used to. I can not see anything getting in the way of where the laser comes out.

I have engraved 3 lines, left to right engraves a double line nearly on top of each other. Up and down engraves 2 lines either side of each other, Diagonally does the same as up and down.

I also...

Hello,
I am cutting something for a customer using an LS3020 using newlydraw. The design has some engrave detail. When I have sent it to cut and it has finished, the engraved lines are doubled as...

I suspected so, its just a pain! Wish there was an easier way. Dont suppose you know any other good cutting software? Im not keen on newly draw as you canno't rotate things to make minor adjustments....

Hello,
I* am doing laser cutting with multiple coloured designes on a layer. When I cut them, due to the width of the laser, there is a gap between the pieces when assembled. I have looked at other...

Hello,
I do laser cutting and engraving and have started to notice that when I engrave letters that I have created in the software that I cut with, that they dont engrave properly. If I import...

Hi,
When I bought my laser I was going to get one from china but found a company near by that sold them. I spoke to them and they said they repair a lot of lasers from china. They are called HPC...