Thank you for the plugin!
I've tried to mill boards with it -
фрезеровка плат, подготовка и наÑтройка Ñтанка перед...
Type: Posts; User: Ivan7
Thank you for the plugin!
I've tried to mill boards with it -
фрезеровка плат, подготовка и наÑтройка Ñтанка перед...
Of course I have! ;-)
6. Zoom buttons works in very small increments, it's almost impossible to zoom into small part of of my work.
It would be great to allow zoom by mouse wheel, and to...
1. is fixed, G92.1 works now!
3.
Balazs tells me, that this mode uses compensation acceleration parameter (used for backlash compensation), not general acceleration value.
I set both...
I've rechecked,
MPG Continuos work fine, smoothing parameter in config does a good job. But it can't move in small increments.
MPG multy is usable with 0.01 step only, with 0.1 and 1mm step my...
Sorry, I mean UC300-5LPT board.
Hello,
I'm using UCCNC + UC300-5LPT for a week, and I want to summarize here a list of bugs in the software I've found.
1. G92.1 is not working as expected. It should reset G92 offset values,...
Hello,
It seems, last 1.2008 version has some support of G18 G19 planes
tested on handwitten sample -
G40
M3S15000
G90
G0Z10.000
G0X-15.000Y0.000