Search:

Hi Mark, do you use axis slaving as you suggested? If you did, then I do not understand how you cut a taper because both pairs of axes should exactly duplicate the master axis (A follows X, Z follows...

Thanx Mark, problem is that the root and tip profiles are different, and cannot be cut with slaving. It solves the feedrate problem, but introduces another. From the deathly silence on this subject I...

I use Profili Pro. I don't think it's the Gcode though. Even a basic test shows the feed rate issue. When I jog or G0 the speed is fine. So a Gcode command of G0 X100 A100 gives me 100mm at speed...

I used that video to set things up, so all pin assignments, motor tuning, soft limits and axis movement directions are good. My issue is specifically with feed rates when using my two horizontal axes...

I have something similar on my setup. My XY work fine, and my AB works fine when operated independently under G01. The moment I operate X with A (both horizontal axes) under G01, both axes run slow....

Newbie alert! Built a 4axis for cutting wings, but struggling with setting up feed rates. All axes work perfectly in direction and speed when operated independently (G01). I have XY set up on my...