Are there any warner & swasey repair people in the charlotte nc area? I have one that needs quite a bit of work.
Type: Posts; User: edthecncman
Are there any warner & swasey repair people in the charlotte nc area? I have one that needs quite a bit of work.
Low way lube will create this problem. Also if the machine just thinks the way lube is low it will go into single block mode. I had to take my lube manifold that is behind the cover on the spindle...
Thanks. Am going to try this now. Would have sooner but was out of town on an emergency repair.
Going to try to be complete and as short as possible. Was having trouble with the machine homing properly and overtravels. Read in the manual to push this key while holding that key down. Long story...
i agree.
Fanuc Robodrill | eBay
other items on my ebay store. Take a look.
The tech guys that Hardinge use are not Hardinge people.They are general repair people and not really Hardinge employees. They are sub contracting their service people from general machine tool...
I think I have ot-b basic parameters. I will look today.
I am looking to get a five or six off preferably hunter twenty pattern made and castings poured. I machine and sell corrugated apron pulleys to the textile machine manufacturing community.. At this...
i have the schematics for a chnc with a OTB fanuc control. I cant imagine the voltages that power the machine would be a whole lot different. if you would like to try an figure these out, message me...
Well I hate to say, but it looks like all of my faith in the hardinge line of machines has dwindled to nothing. I posted a problem with my CHNC on September 21st and here it is, the 29th and the only...
who is the guy...i might know him..
I have checked the incoming power and it is good. when I turn on the mag panel on the back of the machine, the power comes up and the fans start. I have power on the boards on the left hand side of...
I have a chnc I that i have not run for a while. when i powered it up i got a lube fault alarm. the book says that when i get a lube fault alarm, i should turn the control off and back on until the...
two things to watch out for on a machine that has set this long. one: the battery backup is most likely dead and the parameters are all gone. you can get generic parameters for these machines but the...
It has been a while since i fired up this machine. I moved it and powered it up yesterday and it seems that i got the wiring correct as the coolant pump is working and pumping coolant and the collet...
I am running a Haas router with a fanuc controller. at this time we are only using one tool to perform our cutting operation. Our z- word is allways in the neighborhood of -.025. sometime when an...
low way lube...low coolant....high coolant level..turret not seated properly turret not sensing the position....just a few that i can think of right now..all should generate an alarm message, but...
If anyone has a use for the executive tapes for these machines, let me know....i have a couple of the original tapes.
I have a fanuc robodrill that I am trying to program and the cutter comp is giving me a fit for some reason. This machine has been set up on the same job for the last year and i cannot remember how...