Search:

That last post isn't accurate. I wasn't paying proper attention to my multi-meter and all those values are AC and not DC which is concerning. I don't know what I've done but I will keep you posted if...

That PWMbase frequency was a late shot in the dark haha You are correct that I am using the analog output to drive the vfd. When I send the M3 S12000 command, I measured the output of the gecko to...

I changed A062 to 100hz with the control software and when I turned the spindle on, again with M3 S12000 the VFD went to 100hz. Still confused but hoping that assists someone in noticing my error....

I am hoping this is a simple setting and I have accidentally set something. When I issue the command M3 S12000 in mach, my relay kicks in and the spindle starts to speed up. the VFD is displaying...

I hope this isn't a stupid question but I'll ask it anyhow. I have my gecko wired to my Wj200 and the Gecko also controls an in-box relay for water cooling and vacuum systems. When I send the command...

I really appreciate the quick response. It's wired and I flipped the breaker to find its fan turns on and its ready for greatness. I hope turning it on and off via the breaker won't harm it in the...

Before I shower my garage with sparks, I wanted to make sure my electrician and I set the VFD up properly. I have the Hitachi WJ200-002sf that calls for L1 - N - and chassis ground. I had the...