Search:

I have been searching for a .125 oring groove tool to tun an oring groove on some stock . does anyone have any suggestions or part numbers for the holders and inserts . all of the tooling places I...

the leds in the lathe will flicker with out having the vf2 on at all .I am only measuring 12 amps on each phase going into the lathe so its way below the capacity of the phase perfect . I have 6 awg...

Yes , it is just floating right now .I have the ground from the panel going to the ground lug on the transformer case and then to the ground on the cnc . I have been reading up on corner grounding...

I just have it grounded to the transformer case and then back to the panel .

Thanks for the help, we are just starting to get this figured out . we went from a tl1 to an fully loaded st10 so it has a bit of a learning curve .Jim in your picture you have a tool block that...

I have a 30hp phase perfect that goes into a sub panel that feeds a haas vf2ssyt at 240v and it also feeds a 240-480v transformer that runs my haas st-10 lathe . when I have power going to the...

We just bought a used machine and it was wired for 480 so we are looking for an isolation transformer out of a VF series or St series lathe . looks like the transformers are all pretty much the same...

Looking for a used chip chute for a haas vf2 , ours was just ran over by a forklift .I can be reached at 262 960 9517 phone or text . Thanks

We just bought a Haas st10 lathe and are having lots of trouble figuring out the tooling for it . we have the bot turret and still cant figure out how to mount the cutoff tool . any examples and...

I am looking to buy a used Haas SMM2 or a VF1 . please let me know if you have one for sale . [email protected] .

hello, I need some help contouring a pvc tube fitting to fit the od of an 18 inch diameter tube .I have done plenty of 2d work nut no 3d stuff . basically I would like to fixture a 2 inch diameter...

If anyone has a few pictures of the Z axis drive can they please post them . I am interested in how mulicam builds there Zs . would like to see how they connect the servo to the ball screw and if...

Iam looking for a used HSD Es915 spindle in decent condition please email me at [email protected] if you have one for sale .

Thanks

What size steppers did you use ? runs great .

I have been trying to open a G code file for a part I made years ago . I have lost the DFX file and all I have left is the G code that was done in sheetcam around 06 . problem is when I get it opened...

Where did you source your gears at and how many teeth are they ? Looks nice .

This is exactly what I needed to know , I new the shaft would turn into a torsion bar just not sure how much . I was going to use a precision ground a hardened 1 inch shaft supported on baring every...

I am working on my second cnc router , this one will be a 4x8 all steel table . I am having trouble deciding on the x axis drive . I know that I want to to use rack and pinions but i am not sure how...

Hello

I was hoping some one here could help , I am having trouble cutting circles in acrylic with Mach3 . what is happening is there is a small flat spot where the cutter enters and exits the...