Search:

The Deskcnc 2end Generation controller board does have a PWM output. This signal can be used to control Spindle RPM or Laser Power.
There is a setting in the Options menu to choose between Laser and...

Hi,

I apologize for bringing up this old topic, but I was wondering has there ever been a reasonable solution for controlling the original spindle controller by CNC with full control of RPM ? I...

I am in the progress of taking the DeskCNC G2 Controller into operation on a new mill. I have everything wired up and did progressively test all the functions as I completed them. I have the DeskCNC...

Well, if I might add, a glass scale has no backlash but it has a very small linearity error. In most cases the error is so small that it does not matter. The glass scale positioning feedback can help...

Well, I needed two parts and I ended up getting 4 parts so it would be worth while the setup. A single part cost me about $75 shipped ! The parts were made from 7075 Aluminum which I had blasted with...

Thanks everyone for offering service to help me out. I had the parts made and I am extremely pleased with the final cost and accuracy they turned out. I will keep all offers and suggestions in mind...

Well, received a few quotes in the mean time, they are all over the map. I am not sure what some people are smoking, but this is definitely not a $1000 job.

Anyway, Thanks to all who offered...

Oh crapp, are you serious ?

Hi,


I am not sure if I am posting here in the right forum so please forgive me if this is the wrong place for this. I was afraid to be in this position as I am still building my own little CNC...

Hi CR,

thanks for your advise. So with 18 inch (457.2mm) travel on your X3 you are almost there. I understand that overdoing the travel is a bad thing to do, however I based my observation on the...

Well, today I finally started and removed the table and the lead screws.
At this point I am trying to figure out the limit and reference switch layout.
I like to have the switches under the table...

You got it, UPS is an absolute No No when it comes to international shipping.

There are some great stories for you...
...

Hi Kalvin,

no fees at all, go figure. It seems canadian customs are in a good mood these days and have some mercy with the christmas shoppers :).

Cheers

Kay

Yeah, my kit arrived yesterday. Now I need to find some sparetime to get started with the installation.

Cheers

Kay

Hi,

well you need to get your hands on an LCR meter to do that. Checkout Ebay,
there are some cheap once for sale that may be good enough for the job.
Some let you select the measurement...

Hi CR,

Thanks for the warm welcome.

well I was mistaken as I had another look at my motors. It say's on the label Deepgrove, 3A, 3V, 0.9 degrees, 251 oz/in. Unfortunately, the inductance nor...

Hi Kalvin,

looks like there is a common trend, as I am also looking forward to convert mine.
I picked up my Grizzly at the PA showroom couple weeks ago and I am now
eagerly awaiting the...

Hi,

I am new here on this fine forum. I used to be in the CNC industry as an electronics
service engineer until I got fed up with the out of control travel
and poor management that was...