584,866 active members*
5,091 visitors online*
Register for free
Login

Search:

Type: Posts; User: Goover

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    538

    Re: Stepper Amperage

    Its definitely the steppers that are bad. When I test it the X axis works fine. The Z axis didn't move at all I removed the stepper and it was spinning only intermittently when I test it. The Y axis...
  2. Replies
    4
    Views
    538

    Stepper Amperage

    I am retrofitting a mill and the old steppers just aren't working well on all three axis so I am replacing them and the drivers as well. I am planning on keeping the power supply, but I want to make...
  3. I have a LabVolt 5600 with the same drivers....

    I have a LabVolt 5600 with the same drivers. There are four wires coming off the driver they are:

    A yellow wire goes to a terminal on the driver labelled "D"
    A grey wire goes to a terminal on the...
  4. Replies
    4
    Views
    1,277

    Lab Volt 5600 post processor

    I have a Lab Volt 5600 which is running version 3 firmware the mill is I believe from the 2003-2004 time period. The mill runs fine in manual mode so I believe I have a working controller but I do...
  5. Replies
    2
    Views
    1,817

    Lab Volt 5600 serial/null modem cable

    I have a Lab Volt 5600 and the serial cable has one of the connectors pulled off I am not sure what type of cable it is or the wiring diagram for it. Both sides were db9 female connectors. The cable...
  6. Re: Need Goniometer Clamp Lever Milled from Stainless

    It’s been awarded. Muzzy I can’t send you a PM. I have another small stainless part I am going to be looking for quotes on in the next few weeks.
  7. Need Goniometer Clamp Lever Milled from Stainless

    The original part seems to have been an aluminum or magnesium casting which was clear anodized and then painted with baked on paint. It was probably magnesium since it’s an older device, it broke at...
  8. Replies
    0
    Views
    599

    Prolight 2000 questions

    I am looking at buying a Prolight 2000 and I was wondering if anyone know the answers to a few questions which I have.

    First is the Prolight 2000 a true 3 axis mill or is the controller limited to...
Results 1 to 8 of 8