Mate, a normal GPO / powerpoint will handle that no problems.
Relax, put a bit of spit on the plug and stick it in. its all good.
Type: Posts; User: Gippy
Mate, a normal GPO / powerpoint will handle that no problems.
Relax, put a bit of spit on the plug and stick it in. its all good.
You'll be fine. 220V 230V 240V pretty much all the same. The motor and drive won't care
Have a look at the Bosch rexroth drives - pretty sure they do a 2kw unit that can be wired for single phase in.
Hi mate,
If you want to send me a test file, i'll have a go at running a few off - I've only just got the new machine running, would be perfect for this sort of work. (Kuhlmann P25SP)
I'm in...
Any thoughts on running linear scales without the sealing air supply?
90% of my air load is just for these scales - It's an expensive and noisy thing, I'll happily do without if safe to do so.
...
Hi mate,
just tried it - no good, it's a screw in tip , same as a dial indicator.
Hi guys,
I'm getting ready to test a new (old) router, but the spindle is too low - with a 6mm x 30mm (ish) end mill in the Z height probe won't reach the workpiece.
Is there any problem...
Thanks mate,
will be starting up tonight - if there's any dramas, ill be blaming you. :)
Also, if you can get the distance setting pieces for the bits, i'll buy a shirt ton of ya, and also the...
Hi guys,
looking for advice on tooling suppliers for small, quality end mills 6mm and under around the Melbourne area.
I'm about done rewiring the new (mill, engraver, router, machining center)...
Hi mate,
I doubt the parameters have been lost, I work with these drives a fair bit, never really had one lose its memory.
Do you have the plug in keypad / lcd module on the drive? You'll be able...
Just soak the steel in Hydrochloric acid / water mix for 1/2 hour or so, scale will all be gone.
Thanks guys, looks like I'm off to Spotlight to check out their fabric section. The misses reckons they have something similar to inner sole lining.
It's hard to say if the drive is not up to standard re-the earthing. ( i can pretty much guarantee it won't meet most of the other standards). There is no reg that says the motor has to earthed at...
Yeah starting to think so too, especially when its around $80 a sheet, I may even look into cheap acrylic sheet and spray on super glue to start with. Gluing aluminium to mdf could be a pain.
Hi mate, Yeah if I can't get hold of the vac pass through matting - MDF for sure,nice and cheap :)
https://www.youtube.com/watch?v=dIkOocV2vbY
I'll give it a go :)
Hi Roger,
I think you may be confusing this machine with something else?
Not sure why you're saying its not a CNC machine?
it's made with all the good stuff......
Andron controller, bosch...
Hi guys,
I'm looking for a local source or importer of sacrificial Vacuum card / matting.
or any other alternatives?
I can get it from Europe, but wow this stuff is expensive.
cheers
Simon
Thanks mate,
I've been googling flat chat for the last few days - trying to get my head around what this machine can and can't do.
(still waiting for delivery, it's on a back load with a mates...
Hi Guys,
So I have just purchased a Kuhlmann P25SP at pretty much a fire sale - it was going into the scrap metal bin.
This machine was used for sharpening and forming the cutting edges on rotary...