Machine goes to home position in the Z, spindle orients, tool changer moves over, draw bar releases tool, Z axis does not move up, I get an alarm about Z axis overtravel. I have to switch to MDI at...
Type: Posts; User: jetblackaircraf
Machine goes to home position in the Z, spindle orients, tool changer moves over, draw bar releases tool, Z axis does not move up, I get an alarm about Z axis overtravel. I have to switch to MDI at...
The macro that I am running currently is
%
O9001( )
#131=#4003
#130=#4006
G91G28Z
N3M19
N4M21
M26
I am running DNC at 19200. Seems to work okay, but if I set the feed rate too high the com port can't keep up and it will feed, then stop and wait for code. Usually I'm able to run near 100 IPM...
Just wanted to post a link to my youtube video of my Dynamechtronics DM 4500 doing some surfacing on a phenolic test part for what will eventually be an aluminum blade for an axial compressor wheel...
I'm looking for a ball screw and nut to replace the X axis on my Dynamechtronics DM4500M mill. What do you think the chances are of finding a replacement screw that I could machine the ends to fit...
Hey guys,
Just wanted to post an ad offering my machining and fabrication services. My website is www.jetblackaircraft.com and it contains pictures of a few machining, composite, and other...
any ideas?
Hey, can I get a copy of your tool changer program for your Dyna machine? I'm trying to fix mine. Thanks,
Mike
I'm interested too when you find out :-D I was wondering if I could hook up a servo controller other than Mitsubishi. But if I have to run a Mits, that's fine.
Dave,
can i get a copy of your tool changer program just for grins? I've been fighting an issue on my Dynamechtronics with Meldas 520 control for a while. Just curious to see the similarities.
...
Have you got it working yet? I've wired mine for hardware flow control. But, I know the Meldas uses XON XOFF which is software flow control. So, I'm using both, but you should be able to wire...
Hey, if any of you guys have a Meldas controller on a Dyna machine with a 16 tool turret, could you send me your tool change program? I've been trying to get mine to work forever! It works in MDI...
I have a DM4500 Dynamechtronics Mill with a Mitsubishi M3 control. My tool changer is not working in Memory mode. Could someone please post their tool changer macro from their DM4500?
Also, if...
Parlec's website says it's 3.5" / foot which would come out to 16.26 degrees approximately.
Not sure this is the right place to post this... I have a DM4500 Dynamechtronics Mill with a Mitsubishi M3 control. My tool changer is not working in Memory mode. Could someone please post their...
Anyone have a 4500M with Mits 520 control and can give me their tool changer program? should be 9001 or something like that. The two I got from Mits don't work. Actually if anyone can explain what...
I'd have to agree. The print I opened was kind of hard to figure out what you wanted. Also, it looked like you were trying to show how to make them out of a single workpiece. Usually when I get...