Aston Martin?
Type: Posts; User: HeavyMental
Aston Martin?
I forgot to mention...
Delta shows some torque curves in the manual. Looking at the infographic of "General Purpose", they appear to set the two Mids to the same frequency/Voltage and are basing...
I recently had a thread here where I was asking for help with a Huanyang Spindle/VFD. Everyone was very helpful. One thing that was mentioned was that 220V setup would be better. Mine was 110V.
...
I used the settings that you posted for me earlier in this thread. (Thanks again.)
Someone else sent a link to Automation Technologies where they listed basically the same settings you listed...
I just did a little more testing.
Using the pot on the control panel, the VFD only reaches 16020 RPM. Looking at the Hz it is at 267. This makes sense since 267 X 60 (mains frequency) =...
https://www.cnczone.com/forums/attachment.php?attachmentid=486084&stc=1https://www.cnczone.com/forums/attachment.php?attachmentid=486086&stc=1
Just in case I am missing something... which I...
I am finally to the point of bench testing my spindle / VFD.
As much as I would prefer 220V, I have the 110V, 2.2Kw spindle and VFD from Huanyang.
I have entered the settings provided by...
Oh wow! Thank you! That is very generous of your time. I appreciate it.
I am going to study up on this a little more. Someone told me once that the advantage of the VFD is that it has...
Ahh! Makes sense! Thanks!
Thanks so much for the reply.
I must admit, your response regarding the frequencies and voltages confused me even more. So I started going back through the thread again and I saw where you gave...
I apologize if this has been gone over before. I scanned the thread but I couldn't find it.
I am prepping to set up a HY 110V 2.2kW VFD to use with a HY 110V, 2.2kW, 400HZ spindle.
The manual...
Good point. I just happened to have the 1" stock. Maybe I'll see what I can find locally. Mild steel shouldn't be too expensive.
The aluminum bar stock is 2" x 1.5". I am not really familiar...
Greetings! I am a long time lurker here and this is my first post. I did a search but did not find anything.
First, I am not a machinist. I am a woodworker and I have limited access to metal...