Search:

Does anyone know if there is a chart or formula for calculating the cutting speeds for woodruff cutters?

Currently I would like to use a 1" dia x 3/16" width of cut in aluminum. But I would like...

Thanks Bloke, I will give this a try.
You wouldnt happen to have some photos of this you could post do you?

I am all of a sudden having problems with MB1 overshooting Y zero. Does anyone know how to fix this?
X and Z home out just fine but when the Y moves home it moves past it and triggers an emergency...

I noticed the positive too and changed it to -.6.
It doesnt seem to matter what I put in there.
It still is coming up the tap stroke too small error.

Thanks for pointing this out. I thought I did that but after re-reading I see that I did not.

I for one do not think you are wrong. I dont know much the about the Hurco or the post that I used so there may be very well something missing. I didnt remove anything from the tapping code that was...

Hello All,

I am currently in the process of starting my own small machine shop. I am looking for some detail work for our Hurco MB1 Cnc Mill.

I am currently fully employed as a manufacturing...

Shown below is the code that the Hurco Post posted to G Code for Tool 4, which is the 3/8-16 tap:
I am using Mastercam X3 to create the geometry and post the nc g code.
The MB1 controller doesnt...

Hello All,

I just tried tapping today on my Hurco MB1. I am using G code and I keep receiving a "tap stroke too short" message when the tool gets to what I think is the programmed Z depth. I am...