Been a while since posting here, but to answer my own question.
This device uses FreeDOS as its operating system, located on a compact flash card.
The VGA and PS/2 connector can be used for...
Type: Posts; User: RaptorZ
Been a while since posting here, but to answer my own question.
This device uses FreeDOS as its operating system, located on a compact flash card.
The VGA and PS/2 connector can be used for...
Hi All
I'm currently struggling with upgrading my laser engraver from a degraded Coherent Gem 30W to a Coherent Diamond C-80A
However I'm struggling to get anywhere near as much power from the...
Sorry for the very long delay in responding, I've not been around here often.
The color codes are the following
Color - RED - GREEN - BLUE
BLACK - 0 - 0 - 0
RED ...
I need to replace the optics that combine the red dot and 30W CO2 laser in a Lasercam A2.
It seems to be a 19.05 x 3mm optic, that looks like to IIVI ZnSe, however I can't locate a beam combiner...
I can't seem to find the information i'm looking for in other threads, so i'm hoping for some assistance, or pointers in the right direction.
Is it possible to re-calibrate the machine without...
ok, so i have checked the continuity from the drives to the DB9 connector, now i feel like an idiot, somehow I connected the coil across A and B, and the other across A' and B' :(
the machine was a...
Thank you very much for your response, I will have a look to see if i can identify the inductance of the windings.
The current information I can find on the sellers listing are: Stepping motor:57...
Long time lurker, first time poster.
I've finally bought my first CNC mill after a few failed attempts at making a wooden one in the past.
I went for a Chinese 6040 mill, and also ordered a G540. I...
Hi gbraddam, I think im in a similar boat to you, as i also recently purchased a 6040 CNC (Beige, branded CNCEST) containing a PRT-E1500W and also upgraded to a G540
I had numerous issues getting...
I am not exactly sure which plywood it is. It is lightweight, so I would assume that it is Softwood plywood, as its quite lightweight, and splinters quite easily. (it may be spruce, pine, or fir)
...
Hi,
I recently discovered a FabLab near to where I live, and have been visiting it for the last few weeks to make a project.
However i am not sure of the best cutting speeds for the materials i am...