I am speaking of a hand held router vs cnc spindle. hand held you are hogging off full bit depth in a single pass where cnc is minimal on single pass. If I had a 1/2" collet I'd just use what I have....
Type: Posts; User: hankdog
I am speaking of a hand held router vs cnc spindle. hand held you are hogging off full bit depth in a single pass where cnc is minimal on single pass. If I had a 1/2" collet I'd just use what I have....
hey all, long time woodworkers, new to cnc.what is the consensus on 1/8" vs 1/4" bits ? I'm used to using 1/2" shank whenever possible but I understand cnc doesn't have as much side load on bits. ...
Zowwie---- Short answer is "yes" you can use a jointer to SQUARE 4 sides of a board. That doesnt mean you wont have a tapered workpiece. If your jointer fence is adjusted properly to 90 degrees (as...