Hi Angusmac2
I would check the parallelism of the upper and lower guides
see maintenance manual. routine maintenance sect, 2.4.4
also recheck Verticality of wire adjustment sect,2.2.2
Regards...
Type: Posts; User: theblackwatch
Hi Angusmac2
I would check the parallelism of the upper and lower guides
see maintenance manual. routine maintenance sect, 2.4.4
also recheck Verticality of wire adjustment sect,2.2.2
Regards...
Hi cass25z
you are quoting a Parallel (printer) Port on your PC, you will need to use the serial port for the software to work.
it looks to be a 9 D pin connector, If PC does not have a serial...
Hi dresda
your Hard disk is not booting up or is faulty
this is a windows NT system
you need to see if your Hard disk is working
the file the system is looking for should be in the root dir of...
Hi pife82
please check maintenance manual , I. installing the machine, Ch 2 Setting & Adjustment
Have lost all Axis ref points or just some?
If lost all you will have to set your water level as...
Hi Chich
Try Fanuc Oceania
02 8822 4600
Hi minDark
according to the manual Ladder III is a serial com port connection only
that explains the ALM 86 you are getting
connect to serial port on your pc to NC then you should connect....
Hi Shady Bliss
Check ALM on First Servo AMP connected to Optical Cable
the first Servo Amp is in ALM state
Best of Luck
hi Frinkdaddy1
check the maintenance manual Sect II Part 7 "setting the machine zero point"
Hi jesrd
more likely its a ball screw or mechincal issue on the Yaxis
check backlash on both x & Y axis
The Black Watch
Hi Gasit23
check as well as PWE being set=1
also may have to be EMG state and or MDI or EDIT mode
the Black Watch
Hi Robowi
power off the entire machine, also at rear,
Check Emg Stop Switchs,
then power up again.
Also has any extra equipment been added (robot, etc)
check there emg stop switches on them as...
Hi Jeff
This an Open System, which version of windows was it running???
Top row of Green Leds represent PC Cpu card
Bottom Row of Green Leds represent NC CPu Card
do you have the HDD...
Try removing motor, check ballscrew & slides, are they binding??
clean and regrease, using correct grease.
reattach motor & reset zero:wave:
Best of Luck