On our Milltronics ML15 lathe with a Centurion 7 control at power up the following error message shows:
"C:\RAM> c:\CNC\lathe
CNC Halted: error 100.
Centurion VII CNC T7.220p at address...
Type: Posts; User: nweisz
On our Milltronics ML15 lathe with a Centurion 7 control at power up the following error message shows:
"C:\RAM> c:\CNC\lathe
CNC Halted: error 100.
Centurion VII CNC T7.220p at address...
Problem solved!
Thanks for the reply, your assumption was correct Jeff, the machine wiring was (Red=5 volt, White= Ground, Black= Sensor) On the Hall Effect Switch (Red=5 volt, Black=Ground,...
I'm sorry. I did not realize that it was in the Fadal forum. Is there a way to remove it?>
Recently we had to replace one Hall Effect Switch on the ATC slide.
After the new switch was installed the ATC didn't work properly. Made some unusual moves then stopped with no errors.
When we...
We have an old Matsuura MC-760V2 mill with a Yasnac MX2 control.
Lately, at spindle stop (M05) or orient (M19) command usually for tool change, the spindle physically stops or...
This motor is on a Fadal 6030 (1998).
I just replaced the tachometer and the resolver (both new) on the X axis servo motor (Glentek GM6060-50 DC).
After reassembly, it seem to function fine, but...
Thanks for the feedback.
We have checked the board and it looks OK.
I made a few versions of the RS 232 plugs. Some are wired for hardware control. With them loading programs in and out of the...
The machine is a Matsuura MC-760V with a YASNAC MX-2 control. I have no issues with uploading or downloading programs, but when I try to run in Tape (DNC/Drip feed) mode the machine shuts off and the...