I did a simulation like in the Link. And you can see in the attached picture that it is also in the Simulation visible that the two pieces will not fit and that is what I see in reality too.
So I'm...
Type: Posts; User: MXS61
I did a simulation like in the Link. And you can see in the attached picture that it is also in the Simulation visible that the two pieces will not fit and that is what I see in reality too.
So I'm...
Thank you for this link. Obviously others had the same problems and they could solve it. I have checked everything and I tried it again with the same result. The base is too big or the Inlay too...
I have an issue with f-engrave. In the V-Carve Mode the inlay fits only if the prismatic overcut is set to 0. That means that the inlay is too small on its top an fits only on the base of the inlay....