Search:

Hi:


On okuma lathe, I am programing a multiple 90 degree v groove (using 55 degree,1/32 insert, v groving tool,), I tried OD groove and OD wide groove, but didn't get what I want.

Any...

Thanks for all the tips!

We do center drill, drill and reamer to 1 inch long. I tried a new gun drill and it seems the same problem. I didn't measure the hole size and I am planning use a new...

Hi,everyone!

I have gundrilling problem for the last few months, the margin wear out too fast, it will only go about 5 inch deep. it was fine before.
drill size=0.625 speed=1600, feed=0.0012...

Hi,

Can some one help me out?

in IGF programming, when do the process(direction) designation, what MID OD, MID ID, MID FACE are used for?

Thanks!

br

Thanks for help, chucking ring works really good.

Thanks!

I have the program, I throught that I need to change the parameter setting somewhere, otherwise the mahine has alarm if I don't clamp something in the jaw.

when it is not a through soft jaw, I...

when I create a IGF drill program, the x=0, I want the x=-0.2, how to make it happen on IGF.

the following is step I create the program on IGF.

process kind, drill
direction, blind
tools data...

how to make the following program on IGF?

N0200 G97 S2000 M08
N0201 G00 X-0.121 Z0.1 T101010
N0202 G74 X-0.121 Z-2.75 D5.1 L5.1 F0.0025 E0.06
N0203 G00 X-0.3
N0306 G01 Z-0.03 F0.008
N0307...

Need help to change setting for okuma cadet when machine a through soft jaw.

thanks!

Hi, All:

I put wrong value by mistakes at user parameters, and I don't have the old number, how I can find it back? is going to work if run the following program?
N10 VPVLX=[VPVLX+.1]
GOTO N10...

I tried it today, it works!

thanks for help!

Hi, all:

I am learning okuma cnc lathe, osp series, I am wordering if I can stop the machine at single block mode, check the distance then resume from there, no need to start from begining.
...

Hello:

After measuring machined part, I need to make a ajustment to G54, X,Y,Z. I don't know which direction I should move G54,X,Y,Z. when I should Plus or minus?

Thanks for help.

Hi,

I am a new user of Gibbs CAM software, I have two questions hope someone can help.

(1)I am looking for a book, so I can study it by myself.
(2)I can't change the tool tip size,I tried it...

Hey, I am new CNC operator, I hope someone can provide some information for me, lile document or advise a book for basic training on cnc.

thanks!