Hi folks, I'am new at this forum. I have purchased a NVEM motion control card. I'd like to use it for my laser engraver machine. My laser is wired to the spindle out of the controller. The motion...
Type: Posts; User: Grubma
Hi folks, I'am new at this forum. I have purchased a NVEM motion control card. I'd like to use it for my laser engraver machine. My laser is wired to the spindle out of the controller. The motion...
To tell you the trough I mixed up the type numbers. 08AAFJ11 works fine. SGM08A2FJ25 and SGM08A2FJ24 doesn't work. I have Yaskawa DR2 servopacks to try them and used to these motors were wired to DR2...
Hello everyone,
I have a SGM08A2FJ25 servo motor for DR2 servopack. Its work fine.
I also have 2 pieces of 08AAFJ11 servo motor and they not work with the same settings. I think the pulse number...
Hi WT,
You can find these information in user's manual. For your SGM-08AAF-J12 servomotor you must choose an SGDA-08AP servopack.
08 means for 750W motor
A means motor is made for 200V
P means...
Mactec54,
Please try to upload somewhere the file you mentioned earlier.
Thanks
You are right there aren't a lot of I/O-s which are not necessarily needed but this type of servopack neither have got sign and pulse inputs. It has got only a serial bus which I think must be...
Hello,
I have already tried svmon earlier. Several version are available on internet. You can find svmon on Yaskawa's homepage. This is the only version which at least partly recognise this type...
Hello Carlos,
I'm sorry for late reply.
You can find 1CN and 2CN pinout below.
Every second DR2 servopack was made with 20 pin connector, but Yaskawa TS not able to give user's manual about...
Hello all,
I have some Yaskawa DR2 servopacks. User's manual details DR2 types made with 50pin 1CN connector. My servopacks are made with only 20pin 1CN connector. Yaskawa TS says these servopacks...
Dear All,
I'm beginer at Servopacks installation. I have some Yaskawa DR2-02AC and 04AC servopacks. I would like to edit my servopack parameters, but my servopacks don't communicate with pc...