Search:

Sorry it's been so long since my last update. The files that I got off of John worked the treat. I was able to decode my source code file into my machine parameters and my ladder logic. The ladder...

I found a copy of Assemb30 and generated my ladder diagrams with it as well as getting the parameters list. Thanks though!

I have full Schematics from the Machine builder (Wotan) and from Amtek when they did the retrofit to Dynapath back in 1996. I also have the Dynapath users manual. Pinouts and wiring are not my issue....

Do you by chance have a copy of the software?

Hello John, I tried to PM you but not sure if you got my message. My email is shop (at) jorgensenmachineworks (dot) com

That would be a great help if you could send me that info.

OK, so time for an update.

I have been able to get my hands on the original source file from the machine builder, complete with the annotations. Now all I have to do is figure out the syntax of...

They've been gone for years... Previous owner took the entire control out, sent for repair and was told it was a total loss, so abandoned it. That's how I ended up with the mill as he needed it out...

I have a CNC HBM I just acquired. It was previously equipped with a Delta 50M control, but the control got damaged by water and is now long gone. I'm planning to retrofit to LinuxCNC, but I'd like to...

OK. I'll go on the hunt for an amp then...

I'll get an account on the LinuxCNC forum and do some asking over there too.

Question for folks that know more about LinuxCNC than me in regards to two things:

1: It turns out that this mill has a 3 speed spindle transmission. Can LinuxCNC handle automatic gear selection...

Yah, I've basically migrated away from Linux on my desktop to Win10, because I was never able to get Fusion360 working properly on linux in WINE. I honestly would rather run Linux if I could.. My...

I'm located in Southern Michigan, USA.

Linux has had a shaky history with Ryzen, this I am aware of.. I had issues with mine early on, but mostly because I was using the 2400G with built in...

I've not signed up for the LinuxCNC forum yet.

My Ryzen dekstop works good with Ubuntu Linux on it, but never tried it with LinuxCNC.... May have to try the live boot.

Thanks for the...

The AB amps use analog +/- 0-10v inputs. I'm not sure on the encoders vs resolvers situation.

I was planning on using a Dell business pc that has a Core2 Quad. No real reason other than I have it,...

So, I'm in the process of acquiring a Wotan Rapid 1 CNC boring mill with a dead control. Roof leaked water on the cabinet holding the CNC control board and fried it. Machine electrical cabinet stayed...