After replacing obviously blown-up servo-drive, I have this alarm.
Also NC alarms 310 (servo pwr not supplied), 547 (trt not clamped), 543 (trt index error)
drives/hydraulic mtr will not...
Type: Posts; User: zombie1363
After replacing obviously blown-up servo-drive, I have this alarm.
Also NC alarms 310 (servo pwr not supplied), 547 (trt not clamped), 543 (trt index error)
drives/hydraulic mtr will not...
FYI-I have stripped down a similar machine and have many of the boards and both servomotors in good condition if needed.
Most are listed on eBay too...Kevin Germon 316-990-7373 Wichita, KS
Any luck finding 10AA?
Yaskawa quotes about $1900. Not available till the end of May...
I'm not sure that a p/n starting with 20A would work. Those first three digits have to do with the PPR (pulses per rev). I need...
Yes, that indicates a sort of major problem. Tool should be super tight to where you can barely move it with a wrench, if you could get on it good...
If the Bellevilles aren't bad, it could be...
I am in need of the magnetic ring (aka drum) for a integrated spindle motor.
Original p/n is UTMSI-10AABDZE, which is a kit of three parts. The drum, a sensor and a mounting bracket.
I only...
I am in need of the magnetic ring (aka drum) for a integrated spindle motor.
Original p/n is UTMSI-10AABDZE, which is a kit of three parts. The drum, a sensor and a mounting bracket.
I...
I am in need of the magnetic ring (aka drum) for a integrated spindle motor.
Original p/n is UTMSI-10AABDZE, which is a kit of three parts. The drum, a sensor and a mounting bracket.
I only...
I am in need of the magnetic ring (aka drum) for a integrated spindle motor.
Original p/n is UTMSI-10AABDZE, which is a kit of three parts. The drum, a sensor and a mounting bracket.
I only...
The drawings I have do not match machine.
I need documentation for "ladder" version CM-20.
Machine has Fanuc 11 control with an external sequencer.
Will send $$ for your trouble.
The drawing I have do not match machine.
I need documentation for "ladder" version CM-20.
Machine has Fanuc 11 control with an external sequencer.
Will send $$ for your trouble.
Mitsubishi Heavy Industries 1-630-693-4700 x4775 Dave Vrasic?
was able to dig up old files/drawings/documentation for me...
When running at 2500 rpm on the spindle, the spindle motor is maxed out at 5000 rpm.
Commanding S2501 will make machine shift into hi "gear" and motor will only run 1250 rpm and probably run...
Our V-950 is down. We suspect we have the wrong ladder installed in the machine (after total lock-up and board replacement by Mitsubishi.)
We need a back-up file from a similar machine. (Windows...