I have them for a 700c that I can fax to you if you think they will work. zeo
Type: Posts; User: zeo
I have them for a 700c that I can fax to you if you think they will work. zeo
Paul when you do your taper make sure that it is large enought that the back of the chuck and the front of the spindle has some clearance so the that the taper is fully engaged and not bottoming out....
Sure inside the circle that is formed by the 6 sockets that recieve the pins there should be a protursion that sticks out 0.500" and has a diameter of 3.0625. If it is not there I am not sure what...
Paul there should be no slop what so ever. The pins pull the chuck on the short taper on the nose of the spindle D1-5 is 1/2"x3.0625"
The concentricty is all in this little taper so take care of it....
They should fit no problem if they are both the same catagory unit. The pin size, and spacing is part of the D-# sizing reguardless of manufactorer. The pins are used to hold the chuck against a very...