Search:

If you have Ver. 6.6 there is a way you can get the cnc to convert a conversational program to P99996 using simulation.

Hi tmax

I know this is an old post but perhaps youre still out there? I...

Dear all,

We have been using an old Pinacho S94 C/260 with a Fagor 800T controller. This machine while an older model is robust and reliable and allows us to work on some larger parts and one...

Thanks for the info sinha_nsit

Thanks kirit

ill give that a go

Hi Stev01

I have the same problem. We have en old Matsuura running a Fanuc 6MB controller. I am machining a curved slot and wanted to use the G68 command to pattern it around a circle. The...

Hi Folks,

We recently acquired an old Matsuura MC2000V in excellent condition running the Fanuc 6MB Controller. I am pretty new to the G-Code side of things, since most of my recent experience...

Not sure why It didnt attach last time. Lets see if it works this time

Hi Rich,

Turns out the client required an additional tube, and I have really grown to despise the needle file recently so I tried again to figure this out. The tube is 1950 mm long this time,...

Thanks 4 the responses guys.

Rich I may try your method next time this comes up. I basically came to the same conclusion, that I needed a non linear arc in the z, on a full 3 axis machine. It...

thanks for responding 67 cuda,

I suppose, to put it more succinctly, without my previous ramblings, can the standard 3D arc operation cut in three planes at the same time... the manual says that...

hi guys,

have been searching furiously for a solution to the below stated problem, since I haven't got a response, and am out in the cold here... looks like its the needle file so if I don't...

hi guys,

have been searching furiously for a solution to the below stated problem, since I haven't got a response, and am out in the cold here... looks like its the needle file so if I don't...

Hi mazakman,
did you have any success with your 3D chamfering problem... I have the same issue or similar. I am using a much older machine and only in conversational mode. I posted a question...

Hi folks,

I am currently milling, drilling and tapping about 60 side ports in a 6.5" OD 316 Stainless Tube. The holes have a 1" bore and then a series of stepped registers, for mating flanged...

Hi Bloke

spoke with the Hurco rep in Ireland and he is adamant that I cant get that anymore. Any chance you can give me a contact in the US that might be able to help me further?

Hi scaro,

I investigated it further today. We definately dont have the 3D mode software installed. I checked with Hurco Europe, and the rep here in Ireland, and they talked me through where to...

Hi guys,

We are running an old Hurco with Ultimax 3, and I was interested in trying out the 3 D milling option referred to in the manual. Our manual isn't in great condition or complete, as we...

thanks rich,

sorry for not getting back sooner... have been back on the lathe for the last while and hadn't had a chance to try your suggestion s. tried it out last week and worked a treat....

Hi all,

I am looking for some advice on thread milling. Our company recently purchased an old Hurco Hawk 5M in great condition with the Ultimax 3 controller. I am relatively new to cnc milling...