584,866 active members*
5,090 visitors online*
Register for free
Login

Search:

Type: Posts; User: mill808

Search: Search took 0.00 seconds.

  1. Triple Play Solid State Limit Switch Noise Filter

    I have had issues off and on with VFD noise coupling onto my limit switches and causing false trips on the inputs. I have used software filtering with some success and also a relay voltage level...
  2. Replies
    8
    Views
    3,294

    Re: Cambam toolpath problem

    Given the inside corners where the toolpaths cross over to the other side, it could be that corner overcut is turned on for that toolpath.
  3. Re: How do I electrically disconnect my Z axis limit switches

    philbur,
    In Mach3, from the menu bar, select Config ->Ports and Pins, then select the Input Signals tab. You will see the screen below. Clicking on any of the green check marks will disable the...
  4. Re: How do I electrically disconnect my Z axis limit switches

    FYI -This is the relay circuit I used to do the voltage conversion on the limit switches:

    346230

    Using a relay allowed me to use normally closed (NC) switches but still use the normally open...
  5. Re: How do I electrically disconnect my Z axis limit switches

    I just went through this same VFD noise problem. To isolate which limit switch that was falesly tripping, I moved all 3 axis well away from the limit switches. Then I went into the Mach3 Config...
  6. Replies
    4
    Views
    6,174

    Re: Sears sells Craftsman to Stanley

    Sears stores just don't hold the allure that they once did. They don't have the customer draw that they once did, particularly since online buying from the likes of Amazon. Sears is in the death...
  7. Thread: free models

    by mill808
    Replies
    1,096
    Views
    254,207

    Re: free models

    341872
Results 1 to 7 of 7