The chuck was working properly just didnt realize that the stroke for it was so short, and that the jaws had to be adjusted. Figured out the spindle issue was 2 parameters were wrong.
Type: Posts; User: Two Wheel Werkz
The chuck was working properly just didnt realize that the stroke for it was so short, and that the jaws had to be adjusted. Figured out the spindle issue was 2 parameters were wrong.
Anybody have any clues on this problem?, I have a very slimilar problem going on.
Machine is a 86 QT8 with a T2 control. Machine was running before I purchased it from a school. The machine has...
I just purchased a mazak qt-8 and after powering it up I am getting some **** indicating that the parameters have been lost. I have the manuals with the parameter list but as stated noticed once I...
Anyone know how to enable parameter writing? I notice some parameters will not let me change them says something about inadequte information.
OK guys pulled the Z axis motor back off to check ball screw, well I found the flange that goes on the end of the motor did not have a nut on it and it was loose on the shaft. Very interesting as I...
when it says "Check current at check terminal IR and IS at servo amplifier and compare with rated current of motor" should I be checking across these 2 terminals or testing each seperatley? Very...
I am getting a 434 alarm on a fanuc O-MD, some times as soon as it homes, sometimes in the middle of a program . Checked diagnosis #722 reads 00100000 and the only info I can find says "over current...
Ok just wanted to say thanks for the insight guys, seems building a cable to the 3 wire specs worked and solved my problem, or at least that one, lol Now on to the next one.
I have no clue, never cut one apart. By standard I meant it is a off the shelf computer cable that I was using on my milltronics machine previously.
I am using a standard 25 pin to 9 pin cable. planned on trying a new cable with the specs posted but wanted to get some insight to see if it could be program related since it would read nearly the...
Ok guys looking for a little insight on a similar problem to what is posted here. I have been trying to get a machine I purchased up and running for a few day and am really close but have hit a wall....
come on, no one here has any experience with a clausing cnc? just looking for a little input.
want to know how this brand compares to a milltronics.
I am currently looking at a Clausing Stingray with a Fanuc series O-MD controller and was looking for opinions from anyone that has any experience using one. Looking to find out about rpm, what taper...
i am looking for a company to repair a CSM spindle drive from a milltronics mill.
any help would be greatly appreciated. it is a MPA-50-MILL
justin
i notice you just bought this machine, do you know if it might have had any repairs on the computer?
i just had a motherboard put in my partner 7 with centrion 5 and it done the same thing. you...