Search:

I have a ruida rdlc320a controller and a chuck-style rotary attachment connected to my Y axis. I've used this many times with no problems. I just go into LaserWorks, enable rotary, set the diameter,...

I really can't get a good pic of the wiring without taking everything out of the cabinet and I'm not helpful enough to do that for you.

Do you have a link to the specs for your psu? I'll try to...

New to UCCNC. I have been using Mach3 for a while but the erratic nature of it is costing me too much. I cannot get UCCNC to communicate to my controller and I expect the issue is setting the Port...

Is there a way to do that via usb drive or must it be through a direct connection to the pc?

I changed the step length but it still cuts the same size.

I just ran a test, a simple 50mm box. The actual cut was 84.6mm.

Changed Vendor Settings step length graph and measuring length to 50...

I have a Redsail x700 that I am attempting to use with RDWorks. I drew an array of 1/4" squares spaced 1/8" apart. I save to UDisk, load into the laser, and it cuts 7/16 squares spaced at 7/32. The...

Fixed!

After much testing I found that all wires were doing exactly when they should. The laser would also fire when pressing Test on the power supply. So the problem must be the psu, right? Well,...

I can't seem to edit any more, so I'll have to double-post.

I just tested as much as I could think of.

The pair of green wires going to the laser PSU have continuity when all interlock switches...

I just got an x700 and I'm having a bit of trouble. Yesterday I moved the machine into my shop, tested everything to make sure it was working, then went to bed. Today I go to align the mirrors and I...

I've actually been able to run it for about an hour or so straight with no problems. The usb cord was shielded, but the shielding wasn't attached to the ground, making it completely useless. So I...

I just recently got a 6040 and I'm having trouble getting it to work correctly. Mine is a 6040 2.2kw spindle, usb, from GoldRayDigitial as well. I use Planet CNC's software since it works with usb...

I have a fairly large assortment of router bits -- straight, cove box (round end), Vs in various angles, etc.

What would I need to know about if I wanted to use these instead of typical round-nose...

I'm on the fence about one of these 6040 units. I'm new to cnc, so I don't want to spend a ton, but the newer 6040 with the "nowforever" controller seems ok enough for woodworking and glass etching....