From what I read in your post, you have a problem with previously set offsets. Maybe you also have other issues, such as with homing, lost steps, etc., however, the core issue seems to be related to...
Type: Posts; User: SeeAnnSee
From what I read in your post, you have a problem with previously set offsets. Maybe you also have other issues, such as with homing, lost steps, etc., however, the core issue seems to be related to...
I don't know if this helps . . .
I have been using Planet CNC three-relay output boards for spindle speed control for a long time (one for about 10 years and the other about 5 years). I have...
Does the router contain a PlanetCNC-supplied controller (hardware)?
I suspect the router was sold with a counterfeit controller, and that is why the field is grayed-out. All legitimate...
Counterfeit controller, from China?
Klaus:
Thanks for providing your extremely useful scripts.
I do not have any form of programming skills, or knowledge, so your scripts will be extremely helpful to me. It also appears that...
Any plans to add a wiki, or similar feature, for sharing useful and creative TNG2 scripts? This could really unlock the true potential of this software for each user. Perhaps this could be added as...
Meglo82:
Page 5 of your manual provides the necessary information for wiring your output board to the VFD control terminals. The naming of terminals might be somewhat different from what you have...
Thank you.
I didn't realize they were included in the sample folder.
I should probably state that there is a blog entry at planetcnc.com that explains - in very general terms - how to create custom tabs (...
The previous CNCUSB Controller program provided configured “State” and “Programs” tabs that showed setup parameters and program information that were conveniently located on tabs. I found these...
Tantamay:
Have you cleared your work position offsets prior to running your new gcode? I suspect that you still have prior material offset (set by your moveable sensor during your previous job)...
Great work, Andrej!
I just tested the latest beta (2020-05-18) and my gcode ran to completion without any freeze-ups. This was the same code that previously would freeze up at line 35266, just...
I have had a similar problem with TNG2. I reported this off-forum about a month or two ago. From what I can tell, it appears that my ongoing problems might be somewhat related to what is being...
HarryN:
For a strictly hobby-use machine, why would you need anything more elaborate than a simple $2 micro switch?
Something like this:
435968
The reliability, and the repeat ability,...
Have you defined "safe height" within your CAM program, prior to generating your toolpath (gcode)?
Belarusian:
A very impressive ATC build!
I noticed you are using the Barrowich flowmeter. Is this the FBFT032 flowmeter, and what is the typical flowrate (L/hr) does your cooling loop...
I started experiencing "ErrorBuffer" messages at the start of running some jobs. This happens about 5 or 10% of the time.
Attached is a screen-capture image showing the nine register values from...
@Gerry
Thanks for the feedback.
It sounds like V7 is still a work-in-progress, but soon it should have more stability and more working/reliable features.
I tend to use MeshCAM intensely for...
To All Current MeshCAM 6 and MeshCAM 7 users:
I have been a relatively loyal user of MeshCAM for about five or six years, and during this time I have found the software to reasonably useful, even...