[Floriptoolworks]

Picked up a Sharnoa hpm-30. Turns out the manuals with the machine aren't actually for the machine. Tiger 7 Control.

Anybody have one they'd like to share or sell?

[tcfab]

Tiger 5 manual works for everything I've tried. Made a post for Fusion360 using the Tiger 5 manual to set up the canned cycles.

[Floriptoolworks]

Tiger 5 manual works for everything I've tried. Made a post for Fusion360 using the Tiger 5 manual to set up the canned cycles.

Thanks for the info. I'm getting an error from the machine about the tool change position. I'm considering buying a Centroid Oak board to bring everything up to date. I managed to find a manual for the machine so I may try your route to get a post processor setup.

[Ramitamimi]

Did get it,?

[miletrysail]

have you tried reaching out to Sharnoa or searching online forums or marketplaces for CNC machinery manuals? You might find someone who's willing to share or sell a manual for the Tiger 7 Control system. Alternatively, you could contact Sharnoa directly to inquire about obtaining a manual for your specific machine model. snow rider

[Beatricelly]

Tiger 5 manual works for everything I've tried. Made a post for Fusion360 using the Tiger 5 manual to set up the canned cycles.

I used the Tiger 5 tutorial to set up canned cycles in Fusion 360, and everything worked fine.
slope

[liutas4x4]

Hi,

Can you tell me on which brand of servo your machine is built?

I have different manuals for different Sharnoa controls.

Eugenius,
Field service engineer for NC controls (including Sharnoa).