Guy, ah it sells as above on the link I posted for $89 in the USA, so what the hell are you talking about!! The NVMU or whatever I did not buy! The one below that is what I have ordered.
Attachment 438782
Guy, ah it sells as above on the link I posted for $89 in the USA, so what the hell are you talking about!! The NVMU or whatever I did not buy! The one below that is what I have ordered.
Attachment 438782
Retired Master Electrician, HVAC/R Commercial. FLA Saturn 2 4x4 CNC Router Mach4 Kimber 1911 45ACP
Hi,
That means you are being ripped, they are available for $20 elsewhere. To be honest I think $20 is a rip too.Guy, ah it sells as above on the link I posted for $89 in the USA
Craig
Ok Craig the floor is all yours... have at it. Thanks for your help.
Retired Master Electrician, HVAC/R Commercial. FLA Saturn 2 4x4 CNC Router Mach4 Kimber 1911 45ACP
They may not be the same boards the cheap one's may be copies of the original manufactured board this happens a lot $89 sounds about right for a 100Khz board if you compare it with the 100Khz UC100 it is a little cheaper than the UC100 at $89 so may not be a rip off at all get the facts correct, what you are saying is not credible as you don't have hands on experience with this board
Remember electronically challenged installer's will have trouble with any system no matter how fool proof they are made what you see on the forums is typical of people in need of help and 99% are electronically challenged
I have no use for one of these boards but will buy one just to see if they are bad or not
Mactec54
Hello Galoptic
I would like to ask you where you finded bin.file for novusun. I am looking for the bin file for NVEM V2. I suspect that after the connection analog output of spindle to the analog input of inverter the firmware was cleared. Something goes wrong. NVEM worked ok ealier after this situation NVEM not respodnds.
Thank you in advance for your responce
Друг привет.У меня тоже такая проблема возникла.И теперь ни один компьютер не видит устройство.Ты решил эту проблему ?
Files for NVEM here https://www.nvcnc.net/nvem.html
Hi Streumer,
the NVUM-bin file link above has been broken for a while (404 Not Found). it would be a great help if you have the bin file on google drive or a sure download link! I can't find it anywhere online.
thank you
I can sum this up in 2 mins.
The website likely hasn't been updated in last 10 years.
They never patented the controller.
The ones you buy now are copies of the original.
Support does not exist.
Hi,
This link to nvum firmware bin file does not work. COuld you please send the file or a valid link?
I am very in need to fix my novusun cnc controller.
thanks,