[PMFMAN]

We have a Ficep Beam line that our penchure the arm that pushes the steel is getting locked up. We have been on phone with Tech and they keep saying voltage problem but my shop checks and believes the voltage is ok. I have attached a picture of an error code below. Any ideas would be greatly appreciated. Also we are in the Texarkana TX area so if anyone has a reference for a good technician we might could use one.

Attachment 335172

[eduardogonzz]

Hi, I new here, if you ever have any problem with Ficep I can help you.
By the way It seems that it is stock on the process where the machine it is loading and it is waiting for a sensor or a position.
But any way, you may have fixed already.
Have a good day!

[Metalcraft17]

Do you have knowledge of a ficep Excalibur 12?

[netizen445]

Hi, I new here, if you ever have any problem with Ficep I can help you.
By the way It seems that it is stock on the process where the machine it is loading and it is waiting for a sensor or a position.
But any way, you may have fixed already.
Have a good day!

I need some help with a ficep Gemini
Error code ps 5381

[Delongmaint]

Hi, I new here, if you ever have any problem with Ficep I can help you.
By the way It seems that it is stock on the process where the machine it is loading and it is waiting for a sensor or a position.
But any way, you may have fixed already.
Have a good day!

Maybe you can help me with this error. The drill will home just fine but when you try to run a program it stops and gives you this message then will not let you do anything.

Thanks

[Delongmaint]

Found out that it was the nut that holds the hydraulic arm to the vise table had fallen off.

[swazi2002]

Good Day Everybody. I have a ficep DBZ1001 the controller has blown, does anybody know where i could source another one. I have tried ficep and im not getting a response out of them. your assistance would be greatly appreciated.