[blakemachine]

I have a matsuura Mill, 710 machine. Y and Z will rapid fine, using a G28 code, but when I go G28 X0, it will move about two inches then error our with x servo overload. Now I can move the x axis fine, but when I try to go to handle mode, and go fast, it will error out as well. There is no knob to turn down the rapid speed, or if there was, I would just go to like 50% rapid, and run it that way. Is there any suggestions? Is there a way to install a rapid traverse rate switch? What should I look for, as far as the X axis servo motor?

[blakemachine]

Basilcy, if there was a way to turn down the rapid on the controll board for the x axis, that would be the simplist, so it would not move so fast. Any Ideas?

[blakemachine]

Ok, Figured it out, and figured I would post so the archives have the info. There is a blue Potentiameter at the very upper left hand corner of the X axis servo controll board. I turned it about 10 degrees to the right, and it fixed the problem. I think that POT is actually the load alarm circut, and I told it to allow a bit more load. The table was completly free by the way.