[3o33y]

Hello, I'm Enrico from Italy and I'm new in cnczone.
I'm watching to buy a used Masterwood project 330 with a numeric control CN10/c.

I need to know if this control can read and execute the standard ISO code (g code) and if there is a limit of number of lines per program.
There is someone that can send me an example of a program with different movements for this control?

I ask pardon for my bad english.
Thanks very much

[ger21]

I don't know about the 330, But I used a Project 327 with a DOS CN10 control for over 10 years. It didn't use standard g-code, but it's g-code was very similar.

[3o33y]

Hi ger21, thanks for the quick answer.
If the code is similar I can "translate" it.
I have 70000 rows program, do you know if the cn10 control can execute it, or if i can divide it into small parts and execute in sequence automatically?
Thanks in advance, best regards.