I been working on a mv40 w/ yasnac mx3 control circa 1989.
Here is the issue.
When booting up there is multiple errors , It comes down to the 24NC circuit. If booted while holding emergency release and atc button on the side-it boots up with 000 spindle alarm only. Otherwise I get no 24v throught the nc24 circuit. I have switched power supplys to no avail (cpu10nb). I get no output voltage from CN11 at the power supply during normal startup.
Could this be a Thermal relay as the fan on the spindle as it was froze? and replaced. Please help!