Hi everyone.
I'm still having issues with my HPC laser HX40b - Effectively the rabbit but rebranded for the UK market.
over it's brief but (mostly) happy life with me i've had a few issues with it such as focusing properly to do aluminuium dogtags, power to do alu dogtags and general alignment issues.
It's now started to throw major hissy fits.
One of it's current problems is it will start a job fine then at a certain point it will make an awful clunk as both motors stop working and the controllerboard freezes. powercycling does nothing and i have to randomly pull leads on the board until it works again.
Problem the second. it's not lining pieces up properly. the only way i've found to line stuff up right is to draw a square larger than the workpiece then set as do not cut. this then 'normally' lets me position it properly at the home position. not any more it seems.
It's having major issues and i'm seriously considering getting rid.
I no longer have the time or effort to put into it. it's costing me more in materials because i can't do big pieces ithout worrying that the motors are going to stall or it will crash completely
So yeah. ANy help with it would be appreciated.
An offers to take it off my hands would also be welcome ;-)