By "Utility"... you went through the START menu function right? The old switch doesn't work in X3 and X4.
Go to your Windoze Start menu then Programs > Mastercam X(your version) > MCAMX Control Panel Applet. Once there, expand the dialog and select "Post support". Select "enable" and close the window using the check mark.
Open your MCX and when you post, you'll see a little "bug" in the bottom left corner of the pop up. Select the 'bug'.....
X4 is very enhanced so you may want to read over the Help files to get around.
It's just a part..... cutter still goes round and round....
We use cookies to optimize our website for you and to be able to improve it continuously. By clicking the "Accept" button, you expressly agree to the use of cookies. For further information on cookies, please refer to our privacy policy.