[rough_cut]

Hi All,

I recently got myself a copy of Gibbscam and am trying to post a program to my fagor 8055 controller. I have managed to post a program but nothing works, axis overrun, circular motion programmed wrong etc. etc. It just doesn't work. Can someone please take pity on me and run me through, step by step, how to post a program properly.

specs. Gibbscam V8 2007 to a Fagor 8055m controller.

Thanks in advance guys!

[Fagor - Todd]

I know that Gibbs has a good post for most Fagor CNC configurations..... thus, if you haven't gotten the Fagor post from Gibbs, you should contact them. These things are typically just minor problems associated with the correct code format.

If you have additional questions, call Mohit at 905-670-7448.... he is a well informed Fagor Engineeer who can assist you in all questions. Please adhere to what he says, he has been doing this for a long time and will provide you with correct solutions.

Hope this helps and good luck !
Todd

[rough_cut]

Thanks for the advice Todd, where would I find the Fagor post in Gibbs? I'm pretty new to programming and honestly have only used a tailored Haas post that my professor supplied.