[ddorin]

Hello,

I need to transfer files via DNC (I'm using CIMCO DNC Max) to a Traub TNS 42 or Traub TNL 16, with Traub system TX 8D control and I can't do it at all.
I'm using the serial port.
Does anybody have some documentation for that, or knowledge about any procedure to do that?
If yes, please help.

Thank you,
Dorin

[pulisz]

I have the same problem, but...
I succesfully uploaded a few programs made by others, but the programs written by me doesn't uploaded.
I have the 941 Parity error.
In my guide write "vertical parity error verify the format or the number of characters in block."
So, enybody an idea?
To mention, i downloaded from the machine handinputed programs. This uploaded later correctly, but not terminate the connection...
Excuse me my bad english, I dont have other...