I am new to lathes and was wondering if i am going to be stuck with the G50 coordinate system or if i could actually use the G54-G59 work offsets. The reason I'm confused is that in the programming manual, it shows the work softkey in the offset settings page but i dont see it on the machine. Any help is greatly appreciated.
Oh and it has Fanuc 18-tc controls as well
Thread: Help with Okuma 2sp-20h
Results 1 to 3 of 3
-
04-27-2010, 04:26 PM #1
Registered
- Join Date
- Mar 2010
- Posts
- 0
Help with Okuma 2sp-20h
-
04-27-2010, 07:23 PM #2
Registered
- Join Date
- Aug 2008
- Posts
- 62
Does your control have geometry offsets? If it does,your not obliged to use the G50 coordinate system. You still can if you want to,but don't have to.
Rick
-
04-27-2010, 07:42 PM #3
Gold Member
- Join Date
- Feb 2009
- Posts
- 6028
Might want to post this in the Fanuc forum, since you don't have a real Okuma.
Reply With QuoteSimilar Threads
-
INFO? for programming Okuma LOADERs for OKUMA LFS15-2SP ROBUSTURN TWIN SPINDLE CNC
By ohallock in forum OkumaReplies: 4Last Post: 10-02-2014, 04:58 AM -
Anyone looking for an Okuma?
By donnalyn02 in forum OkumaReplies: 1Last Post: 08-12-2013, 01:54 PM -
Okuma Howa Vs Okuma
By gcrudgington in forum OkumaReplies: 5Last Post: 07-01-2010, 03:11 PM -
Anyone have a manual for a 250psi Okuma TSC pump for Okuma Mill?
By Edster in forum OkumaReplies: 1Last Post: 08-28-2008, 02:09 PM -
Difference between a Okuma & Okuma Howa
By 69owb in forum OkumaReplies: 7Last Post: 06-04-2008, 05:51 PM
Posting Permissions
