I have been hired to program and look after a Morbidelli Author 636 TOP router. We are using AlphaCAM. The machine is 5 x 12 but it is set up now w machine home position on the back/left but the part zero references x off of a pin in the center/left of the table, 2' from the left edge of the table! It comes right up thru the table! Why is this? They can't cut 12' material. Can I set the machine to have it's home position on the right and eliminate the pin at the interior position on the table and make part zero to the back left? The machine has a rake but I don't think that matters. After it clears the table it could just rest at that position.
Also I can't seem to open the post for the machine. I used to run Routech machines and the posts would open in Alphaedit and were easily copied and modified. It is a .arb file type.