I have Mach3 up and running. smooth sailing so far.
Mach3-Plasma, however, won't move my steppers. with the same settings, seems like signals are crossing (the wrong LEDs light up on my breakoutboard).
though it is reading Estop and limit conditions.
Mach3 with the plasma.set (and classic.set) works great.
what is the diff between Mach3-Plasma and Mach3 w/ Plasma screen?
-anthony
Thread: Mach3 Plasma
Results 1 to 2 of 2
-
05-18-2005, 11:11 PM #1
Registered
- Join Date
- Apr 2005
- Posts
- 55
Mach3 Plasma
-
05-19-2005, 12:21 AM #2
Community Moderator
- Join Date
- Mar 2003
- Posts
- 35538
You must have something set differently. Carefully go through all the setup screens and double check everything.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With QuoteSimilar Threads
-
Plasma G-code with Artcam?
By coherent in forum ArtCam ProReplies: 4Last Post: 11-23-2006, 02:31 AM -
CNC Plasma table plans
By krazycnc in forum Waterjet General TopicsReplies: 4Last Post: 05-06-2005, 03:51 AM -
RF shielding against plasma
By HuFlungDung in forum DNC Problems and SolutionsReplies: 6Last Post: 11-18-2004, 04:36 PM -
Plasma cutting mdf.
By ynneb in forum Waterjet General TopicsReplies: 8Last Post: 11-06-2004, 02:56 AM -
Handheld Plasma Cutter with CNC?
By Jim Stein in forum Waterjet General TopicsReplies: 5Last Post: 08-28-2004, 03:41 PM
Posting Permissions
