OK....HELP
I have ran into a (At least to me cause I don't have a clue how to resolve it other than to spend money I can't afford to spend) "BIG" problem on my Enco mill conversion to CNC.
Turns out that my "Stepper" motors are (8-wire) 4-phase motors.
My drive controllers are "3-Phase" controllers.
Am I dead in the water until I can afford to buy new Drive controllers like the Gecko G203V or G201X (or similar)?
Or is there a way to "work around" this?
I Don't want to replace the stepper motors (though would if I have to, but can't afford to do that either) as they are already mounted to the mill.


Here is my controller connection details.