[tomasz987]

Hy everyone!

I have got a Nakamura, with Meldas L1 controller.
I want to know how can I change the (maybe protected) parameters.
On the second and third page of the parameter list, where there is some parameters about the servo x and servo z. I wanted to change theese parameters, because we made some modify on the machine.

Can somebody say how can I change theese parameters (some other parameters are changeable, but what I need are not changeable.

Thank you for the help.
Hy,
Matúz Tamás.

[tomasz987]

I have the solution!
We didn't turn on the machine for a while, and the batteries went dead.
The machine parameters are lost. (I made a backup copy fortunately).
After I turn on the machine, I could write all of the parameters. After I finished, the parameter edit locked itself again.

So if someone need to change the parameters:
1. make a copy from the parameters
2. turn off the machine
3. take out the batteries
4. wait aprox an hour (there are some condensators)
5. turn on the machine
6. write back the paramteres (change what you want)
7. turn off, and turn on again

And done.

I hope I could help.
Tomasz