Greetings, I am adding home and limit switches to a Zenbot and I am using Kcam. Should the switches be normally open or closed? Thanks in advance for any help received.
Greetings, I am adding home and limit switches to a Zenbot and I am using Kcam. Should the switches be normally open or closed? Thanks in advance for any help received.
Select a method which is most foolproof. If a wire breaks on this circuit, will the machine know the difference between the normal and the abnormal condition? And do you care if it knows?
First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)