[pyrohamish]

Using the RZNC 0501 controller on a plasma cutting machine.

What g-code is used to turn the plasma on and off?
The actuator that sends the head down to the work piece seems to turn on at x,y=0,0 and then stays on untill the code has finished running

Is there a setting within the controller that says whether or not the machine will read inputs to control the actuator?

[barbarosbaki]

I have same problem . How do you resolve this problem .

[xjdubber]

is there any sample code in the handheld pendant that you can run to see if it works with that?

[barbarosbaki]

N0000 (Filename: plzdeneme.nc)
N0010 (Post processor: Mach3 plasma.scpost)
N0020 (Date: 13.09.2013)
N0030 G21 (Units: Metric)
N0040 G53 G90 G91.1 G40
N0050 F1
N0060 S500
N0070 (Part: plzdeneme)
N0080 (Operation: Inside Offset, 0, T4: Plasma, 1.5 mm kerf)
N0090 M06 T4 F5000.0 (Plasma, 1.5 mm kerf)
N0100 G00 Z1.0000
N0110 X5.7500 Y5.7500
N0120 M03
N0130 G04 P2
N0140 G01 X104.2500 F5000.0
N0150 Y104.2500
N0160 X5.7500
N0170 Y5.7500
N0180 M05
N0190 G04 P1
N0200 G00 X24.2500 Y55.0000
N0210 M03
N0220 G04 P2
N0230 G02 X24.2500 Y55.0000 I30.7500 J0.0000
N0240 M05 M30

This code is sample but for spindle control . My problem , code M05 plasma don't stop .