Hi, I´m starting my project of building a desktop milling machine. I would like to use linear bearings. Searching the web I found this site:
http://www.misumiusa.com/PDFViewer.a...false&Page=181
http://www.misumiusa.com
The cost of this slides it´s Ok for my budged, But I´m not sure if these slides could be used in a milling machine, my machine will be used to cut aluminum and some steel cuting. I would like to obtain an accuraciy betwwen 0.003 and 0.001 Inches.
I was planing to use the SX2R model. They are cheaper than the THK and the diference in acucuracy doesn´t seem to be that much. However the Preload of the misumi slides seems to be smaller than the preload of the THK. Does anybody have used this slides?